Registration Clutch (Clt1); Pickup Solenoid (Sol1) - Toshiba e-STUDIO182 Service Manual

9.5.13

Registration clutch (CLT1)

(1) Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2) Remove 2 screws and take off registration
roller holder.
Note:
When installing the registration roller holder,
engage the arm of the registration clutch with
the rotation stopper of the registration roller
holder.
(3) Release the harness from the harness
clamp, disconnect 1 connector and take off
the registration clutch.
9.5.14

Pickup solenoid (SOL1)

(1) Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2) Release the harness from the harness clamp
and disconnect 1 connector.
e-STUDIO182/212/242
PAPER FEEDING SYSTEM
Registration roller holder
Rotation stopper
Connector
Harness clamp
© 2009 TOSHIBA TEC CORPORATION All rights reserved
9 - 20
Fig. 9-37
Registration clutch
Fig. 9-38
Connector
Fig. 9-39