Cis Unit Drive Belt-2 - Toshiba e-STUDIO182 Service Manual

(3) Take off the CIS unit drive belt-1.
Note:
When assembling the CIS unit drive belt-1,
assemble it while the fixing screw is
loosened. Then tighten the fixing screw of
the tension bracket.
6.7.10

CIS unit drive belt-2

(1) Take off the scanner top cover.
P.6-17 "6.7.2 Scanner top cover"
(2) Take off the right rear cover.
P.2-21 "2.5.9 Right rear cover"
(3) Take off the CIS unit drive belt-1.
P.6-24 "6.7.9 CIS unit drive belt-1"
(4) Loosen 2 fixing screws of the scan motor.
(5) Take off the CIS unit drive belt-2.
Note:
When assembling the CIS unit drive belt-2,
be sure to perform the tension adjustment for
the scan motor.
P.6-18 "6.7.4 Scan motor (M1)"
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 6-37
Fig. 6-38
CIS unit drive belt-2
Fig. 6-39
6 - 25
Scan motor
e-STUDIO182/212/242
SCANNER
6