Pickup Roller - Toshiba e-STUDIO182 Service Manual

(4) Release 2 latches and take off the paper
empty sensor from the bracket.
9.5.12

Pickup roller

(1) Take off the drawer.
(2) Rotate the pickup roller shaft
counterclockwise to make the rubber surface
of the roller facing down.
Note:
Because the tension is applied to the pickup
roller shaft by the pickup clutch when it is
rotated counter-clockwise, be sure to hold
the shaft while replacing the roller.
(3) Push 2 latches each to take off 2 pickup
rollers.
Notes:
• Be sure to install the pickup roller in the
correct direction when reassembling it.
• When it is difficult to take off the pickup
roller, alternatively follow the procedure
below to remove it.
1. Take off the damp heater unit or
dummy plate.
P.9-18 "9.5.10 Damp heater unit
(DH3) / Dummy plate"
2. Take off 2 pickup rollers by releasing 2
latches each.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Bracket
Fig. 9-34
Fig. 9-35
Pickup roller
Fig. 9-36
9 - 19
Paper empty sensor
Pickup roller
e-STUDIO182/212/242
PAPER FEEDING SYSTEM
9