Disassembly And Replacement; Main Motor (M3) - Toshiba e-STUDIO182 Service Manual

8.5

Disassembly and Replacement

8.5.1

Main motor (M3)

(1) Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2) Disconnect 1 connector, remove 2 screws,
and then take off the main motor.
8.5.2 Toner motor (M2)
(1) Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2) Disconnect 1 connector, remove 1 screw,
take off the toner motor with the bracket, and
then remove 1 bushing and 1 gear.
(3) Remove 2 screws and take off the toner
motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
e-STUDIO182/212/242
DRIVE UNIT
Connector
Connector
Tonner motor
Bushing
Bracket
Bracket
© 2009 TOSHIBA TEC CORPORATION All rights reserved
8 - 6
Main motor
Fig. 8-3
Gear
Fig. 8-4
Tonner motor
Fig. 8-5