Ac Power Supply Cable For The Projector - NEC PH1201QL User Manual

Model No. NP-PH1201QL

AC power supply cable for the projector

The projector is equipped with an IEC60320 C20 inlet to connect an AC power supply cable. Use an IEC60320 C19 compliant AC power cable
connector and ensure that the connector meets the following current capacity specifications.
Power supply voltage
AC 200-240 V
1
2
3
Furthermore, use cables, plugs and connectors that are suitable for the regulations of the country of installation, as shown in the following table.
Germany
Plug: CEE7 Cable: H05VV-F 3G1.5
USA
Plug: NEMA 6-15P Cable: SJT 3 x AWG 14
Installation and Quick-Start Guide
Projector input current
8.2 A
Cable
1
Plug
2
Connector
3
Japan
Connector: IEC 320 C19 Plug: JIS C 8303
China
Connector: IEC 320 C19 Plug: GB2099
POWER SUPPLY
Power cable current capacity
250 V 15 A or higher
Cable: VCTF 3 x 2.0mm Connector: IEC 320 C19
Cable: RVV 300/500 Connector: GB17465.1
Notes
Carefully read the contents
described in this section before
connection and connect the
cables according to the proper
procedure. Inappropriate handling
may cause fatal, serious or other
bodily injuries due to fire or
electric shock.
Before connecting the power
cables, check that the main power
switch of the projector is turned
off. Implement the connection
with AC power shut off.
Be sure to ground the equipment
to ensure safety. Use a power
cable that meets the standards
and power supply voltage of the
country where you are using the
projector and always connect the
equipment to the ground. If the
ground is not connected, it may
cause electrical shocks.
When connecting the power
cable plugs to the AC IN and the
electrical outlet, securely insert
the plugs all the way in. If the
connection between the power
cable plug and the electrical
outlet is loose, the plug area may
generate heat, causing burns and
accidents.
Users in North America:
Use a power cable no longer
than 4.5 m / 14.76 ft according to
National Electrical Code.
page 5