Ac Power Work Specifications (Projector) - NEC NC1700L Installation Manual

Setting Up Your Projector and Chiller Unit

2-3-1. AC Power Work Specifications (Projector)

AC power supply equipment
Do not use any voltage other than those shown below for the AC power supply connected to the projector.
200–240V AC, single phase, power, 50/60Hz
AC power supply cable for the projector
The projector is equipped with an IEC60320 C20 inlet to connect an AC power supply cable. Use an IEC60320 C19 compliant
AC power cable connector and ensure that the connector meets the following current capacity specifications.
Power supply voltage
AC 200–240V
Furthermore, use plugs, cables, and connectors that are suitable for the regulations of the country of installation, as shown in
the following table.
For users in North America
NOTE
Use a power cable no longer than 4.5m/14.76 ft according to National Electrical Code.
Germany
Plug
CEE 7
USA
Plug
NEMA 6-15P
Japan
Plug
JIS C 8303
52
Projector input current
10.7A (MAX)
Plug
Cable
H05VV-F 3G1.5
Cable
SJT 3 x AWG 14
Cable
VCTF 3 x 2.0mm
250V 16A or higher
Cable
Connector
Connector
IEC 320 C19
Connector
IEC 320 C19
Connector
IEC 320 C19
Power cable current capacity