Table of Contents
Advertisement
Model No. NP-PH1201QL
Selecting a test pattern
Switch on the projector and, if necessary,
unlock the keypad.
If the test pattern is assigned a shortcut, press
the shortcut button and the projector will begin
displaying the test pattern.
If there is no shortcut assigned to the test
pattern:
1.
Press the
MENU
button.
2.
Press the
LEFT
or
RIGHT
button to
cycle through the list of menus until
appears on the LCD screen. The
Select
list of menus is as follows:
•
Title Select
•
Configuration
•
(Title Setup)
•
Information
•
...
3.
When
is displayed, press
Title Select
DOWN
.
4.
Press
LEFT
or
RIGHT
until
Title Select
is set to
.
TEST Pattern
5.
Press
again, then press
DOWN
LEFT
to cycle through the list of test
RIGHT
patterns.
6.
When you have arrived at the test pattern
you wish to display, press
ENTER
confirm your choice. The projector begins
displaying the test pattern. An asterisk
mark (*) appears on the LCD screen to
indicate the current selection.
To cancel test pattern display, cycle through
the list again and select OFF, then press
ENTER
to confirm your choice.
Installation and Quick-Start Guide
Title
or
to
OPERATING THE PROJECTOR
Title Select
Title Select
TEST Pattern
Off
Title Select
TEST Pattern
Alignment
Notes
For detailed information about
switching on the projector and
unlocking the keypad, see
Switching the projector on
in this guide.
(*)
(*)
earlier
page 30
Advertisement
Table of Contents
