Table of Contents
Advertisement
3. BASIC OPERATION
Connecting the Power Cable and Turn
on the Projector
Before you turn on your projector, ensure that the computer or video
source is turned on and that your lens cap is removed.
1. Connect the supplied power cable to the projector.
Plug the supplied power cable into the AC outlet.
2. Turn On The Projector
The main power switch is on the rear panel of the projector.
By turning this switch on, the projector will go into its standby
mode and the POWER indicator will glow orange. Only after you
press the 'POWER ON' button on the remote control or projector
cabinet will the POWER indicator turn to green and the projector
will fully turn on.
3. Turn Off The Projector
First press the POWER OFF button on the remote control or the
projector cabinet for a minimum of two seconds. Allow the fan to
cool the projector for three minutes.
This will extend the life of the lamp. After the cooling fan stops
working, the POWER indicator will change to a steady orange glow
and the projector will be in the stand-by mode. Then turn off the
main power switch on the rear panel. The POWER indicator will
go out. If you desire to move the projector then unplug the power
cable.
NOTE: Immediately after turning on the projector, screen flicker may occur.
This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.
CAUTION: Do not turn off the main power while the cooling fan is working.
O F
F P
Power
O W
E R
O N
Switch
O F
F P
O W
E R
O N
POWER
OFF
ON
MENU
-
+
ADDRESS
BS
ENTER
ADJUST
IMAGE
PICTURE
WHITE BAL.
PROJECTOR
ABC
DEF
GHI
1
2
3
Using the Power Cable Stopper
The Power cable wire stopper is provided on the projector so that the
cable cannot be accidentally unplugged from the AC IN.
1. Lift up the wire stopper.
Wire stopper
2. Plug the power cable into the AC IN.
Power cable
3. Lift down the wire stopper to hold the power cable.
E – 11
For North America
For Europe
Advertisement
Table of Contents
