Table of Contents
Advertisement
Model No. NP-PH1201QL
4.
If you are replacing the filters, skip this step.
To clean the filters, use a vacuum cleaner brush attachment to vacuum
away dust from the air filters. Avoid making direct contact without an
attachment or using a nozzle attachment.
5.
Mount the air filters to the projector. Look for an arrow (AIR FLOW↑)
indicating the installation direction on the side of the air filter. Point the arrow
towards the projector.
6.
Close the filter cover.
7.
Tighten the knobs clockwise to secure the cover.
Installation and Quick-Start Guide
CLEANING AND REPLACING THE FILTERS
Notes
Before changing the filters,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the filters, avoid
using excessive force as this may
damage the equipment.
The air filters should be cleaned
every 2000 hours and replaced
after approximately 10,000 hours to
maintain projector performance.
page 23
Advertisement
Table of Contents
