Table of Contents
Advertisement
Model No. NP-PH1201QL
3.
Insert the lens into the mount.
Engage the three locating studs
on the mount.
4.
Rotate the lens clockwise until the studs slide all the way into the
slots.
5. Tighten the two fixing screws
3
Installation and Quick-Start Guide
into the corresponding slots
1
2
on the lens holder.
LENS ASSEMBLY AND FITTING
1
3
3
2
Before changing the lens, always
make sure the projector is switched
off and fully disconnected from its
power supply.
When changing the lens, avoid using
excessive force as this may damage
the equipment.
Take care to preserve the original lens
packaging and protective caps for future
use.
The projector will not power on without
the lens fitted.
Notes
page 17
Advertisement
Table of Contents
