Table of Contents
Advertisement
Model No. NP-PH1201QL
EDID on the DVI inputs
If you are using a computer DVI card or another source that obeys the EDID protocol, the source will automatically configure itself to suit the
projector.
Otherwise please refer to the documentation supplied with the source to manually set the resolution to the DMD™ resolution of the projector
or the nearest suitable setting. Switch off the source, connect to the projector, then switch the source back on again.
Using HDMI/DVI/DisplayPort switchers with the projector
When using a DVI source switcher with the projector, it is important to set the switcher so that it passes the projector EDID through to the
source devices. If this is not done, the projector may not be able to lock to the source or display the source correctly as its video output
timings may not be compatible with those of the projector. Sometimes this is called transparent, pass-through or clone mode. See your
switcher's manual for information on how to set this mode.
Additionally, sources which use HDCP encryption may not display properly when connected to the projector via a switcher. Refer to the
switcher's manual for more information.
Sources
1
Switcher
2
Projector
3
Connection Guide
1
2
EDID
EDID
EDID
The EDIDs in the switcher should be the same as the one in the projector.
SIGNAL INPUTS
3
EDID
Notes
page 38
Advertisement
Table of Contents
