Radius-Server Source-Ip; Radius-Server Timeout - Planet Networking & Communication WSGW-24020 User Manual

User Guidelines
There are no user guidelines for this command.
Example
The following example configures the number of times the software searches the list of RADIUS server hosts to 5 attempts.
Console (config)# radius-server retransmit 5

5.18.4 radius-server source-ip

The radius-server source-ip global configuration command specifies the source IP address used for communication with
RADIUS servers. To return to the default, use the no form of this command.
Syntax
radius-server source-ip source
no radius-server-ip
source — Specifies the source IP address.
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
To define an out-of-band IP address, use the out-of-band IP address format —oob/ip-address.
Example
The following example configures the source IP address used for communication with RADIUS servers to 10.1.1.1.
Console (config)# radius-server source-ip 10.1.1.1

5.18.5 radius-server timeout

The radius-server timeout global configuration command sets the interval for which a router waits for a server host to reply. To
restore the default, use the no form of this command.
Syntax
radius-server timeout timeout
no radius-server timeout
User's Manual of WGSW-24020/WGSW-48040
-26