Table of Contents
Advertisement
match that of a previously configured RADIUS authentication server. The port number must lie between 1 - 65535, with 1812
being the default value.
If the 'acct' token is used, the command configures the IP address to use for the RADIUS accounting server. Only a single
accounting server can be configured. If an accounting server is currently configured, it must be removed from the configuration
using the no form of the command before this command succeeds. If the optional <port> parameter is used, the command will
configure the UDP port to use to connect to the RADIUS accounting server. The IP address specified must match that of a
previously configured accounting server. If a port is already configured for the accounting server then the new port will replace
the previously configured value. The port must be a value in the range 1 - 65535, with 1813 being the default value.
▫
Format
radius server host {auth | acct} <ipaddr> [<port>]
▫
Mode
lobal Config
10.1.16.1 no radius server host
This command is used to remove the configured RADIUS authentication server or the RADIUS accounting server. If the 'auth'
token is used, the previously configured RADIUS authentication server is removed from the configuration. Similarly, if the 'acct'
token is used, the previously configured RADIUS accounting server is removed from the configuration. The <ipaddr> parameter
must match the IP address of the previously configured RADIUS authentication / accounting server.
▫
Format
no radius server host {auth | acct} <ipaddress>
▫
Mode
Global Config
10.1.17 radius server key
This command is used to configure the shared secret between the RADIUS client and the RADIUS accounting / authentication
server. Depending on whether the 'auth' or 'acct' token is used, the shared secret will be configured for the RADIUS
authentication or RADIUS accounting server. The IP address provided must match a previously configured server. When this
command is executed, the secret will be prompted. The secret must be an alphanumeric value not exceeding 20 characters.
▫
Format
radius server key {auth | acct} <ipaddr>
▫
Mode
Global Config
10.1.18 radius server msgauth
This command enables the message authenticator attribute for a specified server.
▫
Default
radius server msgauth <ipaddr>
▫
Mode
Global Config
10.1.19 radius server primary
This command is used to configure the primary RADIUS authentication server for this RADIUS client. The primary server is the
one that is used by default for handling RADIUS requests. The remaining configured servers are only used if the primary server
cannot be reached. A maximum of three servers can be configured on each client. Only one of these servers can be configured
as the primary. If a primary server is already configured prior to this command being executed, the server specified by the IP
address specified used in this command will become the new primary server. The IP address must match that of a previously
configured RADIUS authentication server.
▫
Format
radius server primary <ipaddr>
User's Manual of WGS3-2820/WGS3-5220
409
Advertisement
Table of Contents
