Dot1X User; Radius Accounting Mode; Radius Server Host - Planet Networking & Communication WGS3-24000 User Manual

▫
Format dot1x timeout {{reauth-period <seconds>} | {quiet-period <seconds>} | {tx-period <seconds>} |
{supp-timeout <seconds>} | {server-timeout <seconds>}}
▫
Mode Interface Config
10.1.13.1 no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on this port to the default values.
Depending on the token used, the corresponding default values are set.
▫
Format no dot1x timeout {reauth-period | quiet-period | tx-period | supp-timeout | server-timeout}
▫
Mode Interface Config

10.1.14 dot1x user

This command adds the specified user to the list of users with access to the specified port or all ports. The <user> parameter
must be a configured user.
▫
Format dot1x user <user> {<slot/port> | all}
▫
Mode Global Config
10.1.14.1 no dot1x user
This command removes the user from the list of users with access to the specified port or all ports.
▫
Format no dot1x user <user> {<slot/port> | all}
▫
Mode Global Config

10.1.15 radius accounting mode

This command is used to enable the RADIUS accounting function.
▫
Default Disabled
▫
Format radius accounting mode
▫
Mode Global Config
10.1.15.1 no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the RADIUS accounting function is
disabled.
▫
Format no radius accounting mode
▫
Mode lobal Config

10.1.16 radius server host

This command is used to configure the RADIUS authentication and accounting server. If the 'auth' token is used, the command
configures the IP address to use to connect to a RADIUS authentication server. Up to 3 servers can be configured per RADIUS
client. If the maximum number of configured servers is reached, the command will fail until one of the servers is removed by
executing the no form of the command. If the optional <port> parameter is used, the command will configure the UDP port
number to use to connect to the configured RADIUS server. In order to configure the UDP port number, the IP address must
406