Table of Contents
Advertisement
The WGSW-24020/WGSW-48040 can be configured through an Ethernet connection, make sure the manager PC must be set
on same the IP subnet address with the switch. For example, if you have changed the default IP address of the Switch to
192.168.1.1 with subnet mask 255.255.255.0 via console, then the manager PC should be set at 192.168.1.x (where x is a
number between 1 and 253) with subnet mask 255.255.255.0. Or you can use the factory default IP address 192.168.1.254 to
do the relative configuration on manager PC. The sceen in Figure 4-1 appears.
Logging on the switch
1.
Use Internet Explorer 5.0 or above Web browser. Enter the factory-default IP address to access the Web interface. The
factory-default IP Address as following:
http://192.168.1.254
2.
When the following login screen appears, the system will ask you to enter the username and password.
Default User name: admin
Default Password: admin
The login screen in Figure 4-2 appears.
Notice:
The following section will base on the screens of WGSW-24020, for WGSW-24020 the display will be the same to
WGSW-48040.
Figure 4-1 Web Management via Ethernet
-27-
User's Manual of WGSW-24020/WGSW-48040
4. Web Configuration
Advertisement
Table of Contents
