Switchport General Pvid - Planet Networking & Communication WSGW-24020 User Manual

tagged — Sets the port to transmit tagged packets for the VLANs. If the port is added to a VLAN without specifying
tagged or untagged the default is tagged.
untagged — Sets the port to transmit untagged packets for the VLANs.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how to add VLANs 2, 5, and 6 to the allowed list.
Console (config)# interface ethernet e8
Console (config-if)# switchport general allowed vlan add 2,5,6 tagged

5.27.12 switchport general pvid

The switchport general pvid interface configuration command configures the PVID when the interface is in general mode. To
configure the default value, use the no form of this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
vlan-id — PVID (Port VLAN ID). The vlan-id may belong to a non-existent VLAN.
Default Configuration
VLAN ID=1
Command Mode
Interface configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how to configure the PVID for e8, when the interface is in general mode.
User's Manual of WGSW-24020/WGSW-48040
-34