Table of Contents
Advertisement
community-string — Password-like community string sent with the notification operation. (R ange: 1 - 20 characters)
1 — SNMPv1 traps is used.
2 — SNMPv2 traps is used (Default).
Default Configuration
The default is SNMPv2.
UDP Port - 162
timeout - 15 seconds
retries - 3.
Command Mode
Global Configuration mode
User Guidelines
If a trap and inform are defined on the same target, and an inform was sent, the trap is not sent.
An inform request is held in memory until a response is received or the request times out. An inform can be resent or retried
several times, but traps are sent only once. Network traffic is increased with retries. Therefore, traps and informs require a
trade-off between reliability and resources. Inform requests should be used, if it is important that the SNMP manager receives
every notification. If traffic on the network or memory in the switch is a concern and notification is not required, traps should be
used.
To define an SNMP recipient on the out-of-band port, use the out-of-band IP address format — oob/ip-address.
Use only unicast IP addresses.
Example
The following example enables SNMP traps for host 10.1.1.1 with community string "management" using SNMPv2.
Console (config)# snmp-server host 10.1.1.1 management 2
5.20.7 snmp-server set
The snmp-server set global configuration command sets SNMP MIB value by the CLI.
Syntax
snmp-server set variable-name name1 value1 [name2 value2 ...]
variable-name — MIB variable name.
name value... — List of name and value pairs. In case of scalar MIBs there is only a single pair of name values. In case
of entry in a table the first pairs are the indexes, followed by one or more fields.
Default Configuration
This command has no default configuration.
User's Manual of WGSW-24020/WGSW-48040
-28
Advertisement
Table of Contents
