Sharp MX-2301N Operation Manual page 526

Special Modes
Card Shot
X
Y
4
X
• You can also touch the
• The send size will be selected automatically based on the entered original size.
• After selecting Card Shot, you can touch the [Job Detail Settings] key in the base screen and then the [Original] key
to change the original scan size or the send size. In this case, the screen of this step appears when you touch the
scan size key. For the procedure for setting the send size, see
Press the [COLOUR START] key or the [BLACK & WHITE START] key to scan the
front side of the card.
5
If the destination is an Internet fax destination, press the [BLACK & WHITE START] key.
To cancel scanning...
Press the [STOP] key (
Turn the card over and press the [COLOUR START] key or the [BLACK & WHITE
START] key to scan the reverse side of the card.
Press the same [START] key that was used to scan the front side.
6
Before scanning the back of the card, you can touch the [Configure] key in the touch panel to change the exposure.
To cancel scanning...
Press the [STOP] key (
Downloaded From ManualsPrinter.com Manuals
Cancel
Size Reset
(25 210)
X 86
mm
(25 210)
Y 54
mm
(1) (A)
Y
keys to change the number.
) to cancel the operation.
) to cancel the operation.
Specify the original size.
OK
OK (1) Enter the original size.
• Touch the X (width) numeric value display key and
enter the width.
Fit to
Send Size
• Touch the Y (height) numeric value display key and
enter the height.
(B) (2)
(A) To return the original size to the default size, touch the
[Size Reset] key.
(B) To automatically enlarge or reduce the image to fit the
send size, touch the [Fit to Send Size] key. If you wish
to scan the original at the entered original size, there
is no need to touch this key.
(2) Touch the [OK] key.
"Specifying the send size of the
5-78
SCANNER/INTERNET FAX
image" (page 5-55).
Contents