Sharp MX-2301N Operation Manual page 503

Specifying the send size of the image
Specify the send size as a paper size. If a send size bigger than the scan size is selected, the image will be enlarged. If
a send size smaller than the scan size is selected, the image will be reduced.
• The send size cannot be specified when [Long Size] is selected for the scan size, or when the scan size is specified by
numerical values.
• The send size cannot be specified when [TIFF-S] is selected for the format in Internet fax mode. (The send size is fixed at
A4R (8-1/2" x 11"R).)
Select the mode and display the job detail settings screen.
(1) Touch the [Mode Switch] key and select the desired mode.
1
(2) Touch the [Job Detail Settings] key.
(3) Touch the [Original] key.
☞
JOB DETAIL SETTINGS
Scan
Scan Size
Original
Auto
2
2-Sided
Booklet
2-Sided
Tablet
Scan
Original
Auto
Manual
A4
3
• Depending on the paper size specified for the "Scan Size", it may not be possible to select some sizes for the "Send
Size". Size keys that cannot be specified for the "Send Size" are greyed out to prevent selection.
• To specify an Inch size for the send size, touch the [AB
send size.
Scan
Scan Size
Original
Auto
2-Sided
Booklet
2-Sided
Tablet
4
The ratio used for reduction or enlargement of the original will appear between the "Scan Size" and the "Send Size".
Downloaded From ManualsPrinter.com Manuals
(page 5-50)
100%
Send Size
A4 Auto
Image Orientation
AB Inch
A5 B5R B4 216x340
A5R A4 A3 216x343
B5 A4R
(1)
141%
Send Size
A4 A3
Image Orientation
(1)
Touch the "Send Size" key.
OK
Specify the send size.
OK
(1) Touch the desired send size key.
(2) Touch the [OK] key.
(2)
Inch] key to highlight the [Inch] side and then specify the
Specify the orientation in which the
OK
original is placed.
(1) Touch the appropriate "Image Orientation"
key.
If this setting is not correct when sending an image with a
changed ratio, a suitable image may not be transmitted.
(2)
(2) Touch the [OK] key.
5-55
SCANNER/INTERNET FAX
Contents