"Aa Injectors Installation; "Ba Fuel Pressure Regulator Installation; "Ca Gasket Installation - Mitsubishi 4G9 User Manual

4G9 ENGINE (E - W) -
Injector connector
A
Delivery pipe
<SOHC - MPI for other
than PAJERO io>
Projection
E
Mitsubishi Motors Corporation
Fuel and Emission Control System
INSTALLATION SERVICE POINTS

"AA INJECTORS INSTALLATION

(1) Apply a small amount of new engine oil to the O-ring.
(2) While turning the injector to the left and right, install it
(3) Check that the injector turns smoothly. If it does not turn
B
(4) Check that the clearance between the injector connector

"BA FUEL PRESSURE REGULATOR INSTALLATION

(1) Apply a small amount of new engine oil to the O-ring.
(2) Check that the fuel pressure regulator turns smoothly.

"CA GASKET INSTALLATION

(1) Position the projection as shown in the illustration.
Dec. 1998
Caution
Be sure not to let engine oil get into the delivery
pipe.
to the delivery pipe.
smoothly, the O-ring may be trapped. Remove the injector
and check the O-ring for damage, and then re-insert it
into the delivery pipe and check once again.
and the delivery pipe is uniform (A = B).
Insert the fuel pressure regulator into the delivery pipe
being careful not to damage the O-ring.
Caution
Be sure not to let engine oil get into the delivery
pipe.
If it does not turn smoothly, the O-ring may be trapped.
Remove the fuel pressure regulator and check the O-ring
for damage, and then re-insert it into the delivery pipe
and check once again.
PWEE9502-E
11A-5-5
Added