To Install The Oil Seal; Sealant Application To Oil Seal Case; Drive Plate Bolt/Flywheel Bolt Installation; Crankshaft Journal Oil Clearance (Plastigauge Method) - Mitsubishi 4G9 User Manual

4G9 ENGINE (E–W)
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
–
Crankshaft, Cylinder Block, Flywheel and Drive Plate
"DA OIL SEAL INSTALLATION
MB990938
MD998776
"EA SEALANT APPLICATION TO OIL SEAL CASE
"FA DRIVE PLATE BOLT/FLYWHEEL BOLT
(1) Remove all the ramaining sealant from bolts and thread
(2) Apply engine oil to the flange of bolt.
(3) Apply engine oil into the thread holes of crankshaft.
(4) Apply specified sealant to the thread of bolts.
(5) Tighten the bolts to specified torque.
INSPECTION
CRANKSHAFT JOURNAL OIL CLEARANCE
(PLASTIGAUGE METHOD)
(1) Remove oil from the crankshaft journal and he crankshaft
(2) Install the crankshaft.
(3) Cut the Plastigauge to the same length as the width of
Plastigauge
(4) Install the crankshaft bearing cap carefully and tighten
(5) Carefully remove the crankshaft bearing cap.
(6) Measure the width of the Plastigauge at its widest part
Plastigauge
Nov. 1995
Mar. 2001
Specified sealant:
Mitsubishi Genuine
equivalent
INSTALLATION
holes of crankshaft.
Specified sealant:
3M Nut Locking Part No. 4171 or equivalent
bearing.
bearing and place it on the journal in parallel with its
axis.
the bolts to the specified torque.
by using a scale printed on the Plastigauge package.
Standard value: 0.02 – 0.04 mm
Limit: 0.1 mm
PWEE9502-A
PWEE9502-I
11A-12-5
Part No. MD970389
Revised
Revised
or