Pump Camshaft Case Installation; Fuel Pressure Sensor Installation; Fuel High Pressure Regulator Installation - Mitsubishi 4G9 User Manual

11A-6c-4
4G9 ENGINE (E - W) -
<CARISMA>
3 1
<PAJERO io>
3 1
Coupling
O-ring
key
Backup ring
E
Mitsubishi Motors Corporation
Injector and Fuel Pump Assembly (GDI)
(8) Tighten the fasteners of the delivery pipe and injector
4
2
2 4
"CA PUMP CAMSHAFT CASE INSTALLATION
(1) Apply small amount of engine oil to the O-ring (larger
Groove
(2) Install the pump camshaft case onto the cylinder head
Camshaft
(3) Tighten the case mounting bolts to the specified torque.
"DA FUEL PRESSURE SENSOR INSTALLATION
(1) Install the backup ring to the fuel pressure sensor with
(2) Install the fuel pressure sensor straight into the fuel
(3) Tighten the fuel pressure sensor mounting bolt to the
Cut surface
"EA FUEL HIGH PRESSURE REGULATOR
(1) Install the fuel high pressure regulator on the pump
Cut surface
Backup ring
Dec. 1998
assembly to the specified torque in the order given in
the illustration.
one) on the case.
while aligning the coupling keys of the case with the
grooves in the rear end face of the camshaft.
NOTE
The coupling keys and the grooves at the camshaft rear
end are offset with respect to the camshaft center.
its inside cut surface in the illustrated direction.
pressure regulator with labeled surface upward.
specified torque.
INSTALLATION
camshaft case <for CARISMA> or onto the spacer <for
PAJERO io> and tighten the 3 bolts lightly (with somewhat
larger torque than fingertight). Tightening to the
specification is to be carried out in the step described
in "FA.
PWEE9502-E Revised