Lash Adjuster Removal; Adjusting Screw Installation; Rocker Arm Shaft Installation; Rocker Arms And Rocker Arm Shaft Installation - Mitsubishi 4G9 User Manual

4G9 ENGINE (E - W) -
Timing belt side
Chamfered side
Oil holes
E
Mitsubishi Motors Corporation
REMOVAL SERVICE POINT
AA" LASH ADJUSTER REMOVAL
INSTALLATION SERVICE POINTS
1 mm or less
"AA ADJUSTING SCREW INSTALLATION
(1) Install provisionally the screw to the rocker arm. Insert
"BA ROCKER ARM SHAFT INSTALLATION
(1) Place the end with the larger chamfered side toward the
(2) Install the shaft with the oil holes toward the cylinder
"CA ROCKER ARMS AND ROCKER ARM SHAFT
(1) Move the rocker arms in the directions shown in the
"DA ROCKER ARM SPRING INSTALLATION
(1) Insert the rocker arm spring at an angle to the spark
Dec. 1998
Rocker Arms and Camshafts
Caution
D
If the lash adjuster is re-used, clean the lash
adjuster. (Refer to 11A-8-10.)
it so that the end of the screw is flush with the edge
of the rocker arm or projects slightly (1 mm or less).
timing belt side.
NOTE
The rocker arm shaft for intake valves has eight oil holes.
head.
INSTALLATION
illustration before tightening the rocker arm shaft bolts.
NOTE
Move the rocker arms until they touch the rocker arm
shaft mounting bosses on the cylinder head.
plug guide and then install it so that it is at a right angle
to the guide.
PWEE9502-E
11A-8-5
Revised