Removal Service Point Aa" Crankshaft Bolt Removal; Installation Service Points "Aa Cam Position Sensor Support; "Ba Front Flange/Crankshaft Pulley/Crankshaft Bolt Installation - Mitsubishi 4G9 User Manual

4G9 ENGINE (E–W) –
MD998781
MD998781
Crankshaft pulley
Crankshaft bolt
Washer
Big chamfered side
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
REMOVAL SERVICE POINT
AA" CRANKSHAFT BOLT REMOVAL
(1) Use the special tool to hold the flywheel or the drive
INSTALLATION SERVICE POINTS
"AA CAM POSITION SENSOR SUPPORT
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
"BA FRONT FLANGE / CRANKSHAFT PULLEY /
(1) Use the special tool to hold the flywheel or the drive
(2) Clean and then degrease the front flange contacting
Front flange
Crankshaft
Clean
(3) Clean the bolt hole in the crankshaft, the crankshaft
(4) Apply an appropriately small amount of oil to the threads
Degrease
(5) Tighten the crankshaft bolt to the specified torque of 182
Nov. 1995
Jun. 2002
Alternator and Ignition System
plate, and then loosen the crankshaft mounting bolts.
INSTALLATION
the area shown.
Specified sealant:
Mitsubishi Genuine
equivalent.
CRANKSHAFT BOLT INSTALLATION
plate.
surface of the crankshaft pulley.
NOTE
Degreasing is necessary to prevent decrease in the friction
between contacting surfaces.
contacting surface and washer contacting surface of the
crankshaft pulley, and the washer.
and seating surface of the crankshaft bolt.
4 Nm.
PWEE9502-A
PWEE9502-K
11A-3-7
Part No. MD970389
Revised
or