Semi-Circular Packing Installation; Camshaft Holder Assembly Installation; Install The Camshaft; Camshaft Bearing Cap/Camshaft Holder Installation - Mitsubishi 4G9 User Manual

4g9 series
Hide thumbs Also See for 4G9:
Table of Contents

Advertisement

4G9 ENGINE (E - W) -
Sealant
Sealant
E
Mitsubishi Motors Corporation
Rocker Cover and Camshafts (MIVEC)
INSTALLATION SERVICE POINTS
"AA SEMI-CIRCULAR PACKING INSTALLATION
(1) Apply the specified sealant to the area shown.
"BA CAMSHAFT HOLDER ASSEMBLY INSTALLATION
(1) Apply the specified sealant to the area shown.
"CA CAMSHAFT INSTALLATION
(1) Ensure that the intake-side and exhaust-side camshafts
(2) Set the No. 1 piston at the top dead center and install
"DA CAMSHAFT BEARING CAP / CAMSHAFT
(1) Confirm the identification mark on each bearing cap to
Nov. 1995
Specified sealant:
3M ATD Part No. 8660 or equivalent.
Specified sealant:
3M ATD Part No. 8660 or equivalent
are not reversed. The exhaust-side camshaft is longer
and has a slot in its rear end.
the camshafts with their cams for No. 1 cylinder directed
upward so that the No. 1 cylinder becomes the top dead
center on the compression stroke.
HOLDER INSTALLATION
install the cap in the correct position.
Identification mark
L1: Front bearing for exhaust camshaft
R1: Front bearing for intake camshaft
PWEE9502-A
11A-8a-3
Added

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents