Oil Seal Installation; Lash Adjuster Installation; Camshaft Installation; Bearing Cap Installation - Mitsubishi 4G9 User Manual

11A-8-6
4G9 ENGINE (E - W) -
MD998713
Journal
Dowel
pins
E
Mitsubishi Motors Corporation
"EA OIL SEAL INSTALLATION
"FA LASH ADJUSTER INSTALLATION
(1) Fit the lash adjuster onto the cylinder head using care
"GA CAMSHAFT INSTALLATION
(1) Apply engine oil to the camshaft journals and cam before
Slit
"HA BEARING CAP INSTALLATION
(1) Locate the camshaft dowel pins as illustrated.
(2) Apply sealant to the locations shown in the illustration.
Dec. 1998
Rocker Arms and Camshafts
Caution
D
If the lash adjuster is re-used, clean the lash
adjuster. (Refer to 11A-8-10.)
not to allow diesel fuel to spill out.
installing the camshaft. Use care not to confuse the intake
camshaft with the exhaust camshaft.
NOTE
The rear end of the intake camshaft is provided with
a 4 mm-wide slit.
Specified sealant:
3M ATD Part No. 8660 or equivalent
PWEE9502-E Revised