Water Pump Installation; Water Inlet Pipe (Front Wheel Drive/Water Pipe, Rear Wheel Drive/O-Ring Installation); Thermostat Installation; Water Outlet Fitting Installation - Mitsubishi 4G9 User Manual

4G9 ENGINE (E–W) –
Jiggle valve
<FRONT WHEEL DRIVE>
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
INSTALLATION SERVICE POINTS
"AA WATER PUMP INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
"BA WATER INLET PIPE <FRONT WHEEL
(1) Replace the O-ring of the water inlet pipe <FRONT WHEEL
"CA THERMOSTAT CASE INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
"DA THERMOSTAT INSTALLATION
(1) Install the thermostat so that the jiggle valve is facing
"EA WATER OUTLET FITTING INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
Nov. 1996
Jun. 2002
Water Pump and Water Hose
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent
DRIVE>/WATER PIPE <REAR WHEEL
DRIVE>/O-RING INSTALLATION
DRIVE> or water pipe <REAR WHEEL DRIVE>, and then
apply water to the O-ring to make installation easy.
Caution
1. Never apply any oil or grease to the O-ring.
2. Secure the water pipe after the thermostat case
has been installed.
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent
straight up.
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine
equivalent
PWEE9502-B
PWEE9502-K
11A-7-5
Part No.MD970389
Revised
Revised
or