Set-Up Face Removal - FireplaceXtrordinair 36DV-A/R Owner's Manual

F
INALIZING THE
! ACID WASH WARNING: Before installing the faceplate, make sure any masonry that has been
treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid
wash (muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia
solution, the gold face may develop a permanent tarnish when the acid evaporates over time.
Contact your dealer if uncertain your facing has been properly neutralized.
1 Remove and discard the set-up face following the directions below.
Remove the
screws holding
the set-up face
on the fireplace
with the #3
square driver
included with
the fireplace.
I
NSTALLATION
NOTE: the 36DV-R
only has four screws
Set-up face
Set-up Face
(may be discarded)
- For Qualified Installers Only!
The facing should be installed prior to
removal of the set-up face.
P 19
AGE