Finalizing The Installation; Remove Set-Up Face - FireplaceXtrordinair Xtrordinair 44 Elite Installation Manual

26

Finalizing the Installation

Finalizing the Installation
ACID WASH WARNING Before installing the faceplate, make sure any masonry that has been
treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid
wash (muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia
solution, the gold face may develop a permanent tarnish when the acid evaporates over time.
WOOD SCRAP WARNING Never burn wood scraps in the fireplace. Treated wood breaks down the
catalyst inside the fireplace, decreasing efficiency and increasing emissions.

Remove Set-Up Face

•
Remove the set-up face using a phillips screwdriver (see Figure 31).
•
Make sure the insulation between the firebox and fireplace can is still in place (see Figure 32).
© Travis Industries
(for qualified installers only)
Use a phillips screwdriver to remove
the 10 screws holding the set-up
face in place.
Before putting on the faceplate, make
sure the insulation is in place and forms
a barrier between the firebox and the
zero-clearance can. Check both sides
and above the firebox.
4050714
Phillips
Screwdriver
Figure 31
Figure 32
93508093