Rep 6.0.7 Paper Size Switch - Xerox Phaser 8560MFP Service Documentation

Figure 2 Removing the Waste Tray Cover
8. Disconnect the Waste Tray Detect Sensor (P/J110) from the I/O Board.
9. Unlace the sensor harness from the retainers and guides.
10. Release the hooks that secure the sensor to the cover and remove the sensor.
Figure 3 Removing the Waste Tray Detect Sensor.
Replacement
Perform the Head Tilt Gear (ADJ 4.13.1), and Process Drive Alignment (ADJ 4.7.1) adjust-
ments before restoring system power.
Initial Issue
Phaser 8510/8560MFP Multifunction Product

REP 6.0.7 Paper Size Switch

Parts List on PL 6.0
Removal
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Right Side Cover (REP 1.0.21).
4. Remove Tray 2.
5. Disconnect the Paper Size Switch (P/J600) from the I/O Board.
6. Unlace the harness from the retainers.
7. Use pliers to push the latch rearward and release the front of the switch from the chassis.
Figure 1 Removing the Paper Size Switch
8. Pull the harness through the opening in the chassis and remove the switch from the tray
cavity.
10/2006
4-67
Repairs and Adjustments
REP 6.0.6, REP 6.0.7