Rep 3.0.4 Duplex Roller; Rep 3.0.5 Upper Duplex Guide And Solenoid - Xerox Phaser 8560MFP Service Documentation

REP 3.0.4 Duplex Roller

Parts List on PL 3.0
Removal
1. Open the Front Door.
2. Remove the Outer Duplex Guide (REP 3.0.6).
3. Remove the Lower Inner Duplex Guide (REP 3.0.2).
4. Remove the KL-Clip on the left end of the roller shaft, move the bearing to the right, slide
the shaft to the left to release the right end from the chassis, and lift the right end upward
to clear the top of the frame at the right.
Figure 1 Removing the Duplex Roller
Repairs and Adjustments
REP 3.0.4, REP 3.0.5

REP 3.0.5 Upper Duplex Guide and Solenoid

Parts List on PL 3.0
Removal
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Right Side Cover (REP 1.0.21).
4. Remove the Outer Duplex Guide (REP 3.0.6).
5. Disconnect the solenoid (P/J250) from the I/O Board and release the harness from the
right side retainers to remove the guide from the printer.
Figure 1 Removing the Upper Duplex Guide
10/2006
4-40
Initial Issue
Phaser 8510/8560MFP Multifunction Product