Rep 3.0.18 Pick And Retard Rollers - Xerox Phaser 8560MFP Service Documentation

REP 3.0.18 Pick and Retard Rollers

Parts List on PL 3.0
Removal
The Pick Roller catch is located on the ceiling of the tray cavity about 1/4 of the way across the
unit from the right side, and about 5 in. (12.5 cm) back. When you pull forward on the catch, the
roller swings down.
1. Remove Tray 2.
2. Release the Pick Roller catch and pull downward to remove the roller.
Figure 1 Replacing the Pick Roller
3. Lift the Retard Roller to vertical, then pull the roller from the shaft in the tray. See Figure 2.
Repairs and Adjustments
REP 3.0.18
Figure 2 Replacing the Retard Roller
Replacement
For the Pick Roller, insert the replacement roller with the metal shaft at the top and toward the
left. The grey rollers should be facing you. Position the roller back about 2 inches (5 cm) in the
tray cavity. Fell for a large plastic lip on the right and the mating gear on the left. Rotate the Pick
Roller up and back to snap it into place.
10/2006
4-44
Initial Issue
Phaser 8510/8560MFP Multifunction Product