Rep 2.0.12 Stripper Carriage Assembly - Xerox Phaser 8560MFP Service Documentation

REP 2.0.12 Stripper Carriage Assembly

Parts List on PL 2.0
Removal
1. Remove the Scanner Assembly and attached DADF (REP 1.0.11).
2. Remove the Right Side Cover (REP 1.0.21).
3. Remove the Output Tray (REP 1.0.6).
4. Remove the Outer Duplex Guide (REP 3.0.6).
5. Remove the Upper Duplex Guide (REP 3.0.5).
6. Prop open the Exit Door.
7. Disconnect P/J250 from the I/O Board.
8. Remove 2 (plastic, T-20) screws that secure the I/O Board to the chassis. Slide the board
towards the rear to release it from the ground strap, and then downward to position it out
of the way.
9. Loosen 1 (plastic, T-20) screw that secures an I/O Board ground strap and the Transfix
Roller Shaft Restraint, then remove the restraint.
Figure 1 Removing the Transfix Roller Shaft Restraint
Repairs and Adjustments
REP 2.0.12
10. Hold the Transfix Roller and Stripper Blade with one hand, engage the end of the Transfix
Roller Shaft with the Transfix Roller Shaft Restraint and pull the shaft out of the Stripper
Carriage Assembly.
11. Lift the Stripper Carriage Assembly and Transfix Roller up and out of the chassis.
Replacement
NOTE: Make sure the I/O Board Ground Straps are properly positioned and the I/O Board is
behind the chassis retainers before installing the 2 I/O Board screws.
10/2006
4-30
Initial Issue
Phaser 8510/8560MFP Multifunction Product