REP 5.0.8 RAM
Parts List on PL 5.0
Removal
RAM is vulnerable to ESD. Review ESD procedures presented in Section 1.
1.
Loosen the thumbscrews on the back cover of the Electronics Module.
NOTE: Observe the orientation of the RAM device before removing it from the board.
2.
Disconnect the RAM module from the Electronics Module.
Figure 1 Removing RAM
3.
Insert the replacement RAM and close the Back Cover.
Initial Issue
Phaser 8510/8560MFP Multifunction Product
CAUTION
REP 5.0.9 NVRAM
Parts List on PL 5.0
Removal
NVRAM is vulnerable to ESD. Review ESD procedures presented in Section 1.
1.
Loosen the thumbscrews on the back cover of the Electronics Module.
NOTE: Observe the orientation of the NVRAM devices before removing it from the board.
2.
Exchange the NVRAM devices.
Figure 1 Removing NVRAM
10/2006
4-61
CAUTION
Repairs and Adjustments
REP 5.0.8, REP 5.0.9