Rep 1.0.7 Left Side Cover; Rep 1.0.8 Scanner Hinges - Xerox Phaser 8560MFP Service Documentation

REP 1.0.7 Left Side Cover

Parts List on PL 1.0
Removal
1. Open the Front Door.
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
4. Remove the (metal, T-20) screw at the back of the system that secures the cover to the
frame.
Figure 1 Removing the Left Side Cover
5. Release the tab near the top of the cover using a flat-blade screwdriver.
6. Release the tabs along the front of the cover that secure it to the Exit Module.
7. Pull outward on the front of the cover to release it from the frame.
Replacement
Insert the 3 tabs along the bottom edge of the cover into the slots in the frame before snapping
the cover into place.
Repairs and Adjustments
REP 1.0.7, REP 1.0.8

REP 1.0.8 Scanner Hinges

Parts List on PL 1.0
Removal
If possible, lock the Scanhead before removing the assembly. A utility for locking the Scanhead
is provided in the Service Tools Menu. Power down the printer with the DADF closed.
1. Remove the DADF (REP 1.0.15).
2. Disconnect the Scanner Assembly from the printer.
3. Place the Scanhead in the locked position for removal.
Figure 1 Unlocking the Scanner Assembly Hinges
4. Release the hinge latches using a screwdriver or pen.
5. Slide the Scanner Assembly towards the back, and then lift to remove it from the printer.
6. Remove the 4 (plastic T-20) screws that secure each hinge to the assembly.
10/2006
4-6
CAUTION
Phaser 8510/8560MFP Multifunction Product
Initial Issue