Rep 6.0.11 Output Tray Full Sensor - Xerox Phaser 8560MFP Service Documentation

REP 6.0.11 Output Tray Full Sensor

Parts List on PL 6.0
Removal
The Output Tray Full Sensor consists of two circuit boards mounted on either side of the Output
Tray. Replace both boards when servicing this sensor.
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7).
4. Remove the Right Side Cover (REP 1.0.21).
5. Remove the Exit Elevator Motor (REP 4.0.9).
6. Disconnect the Output Tray Full Sensor connectors (CN801 and CN802).
7. Remove 2 (plastic, T-20) screws that secure the left and right boards to the chassis.
Initial Issue
Phaser 8510/8560MFP Multifunction Product
Figure 1 Removing the Output Tray Full Sensor
10/2006
4-69
Repairs and Adjustments
REP 6.0.11