Starter Interlock And Electrical Switches 1.22 - Buell Blast 2014 Service Manual

HOME

STARTER INTERLOCK AND ELECTRICAL SWITCHES 1.22

GENERAL
Lubricate sidestand with LOCTITE LUBRIPLATE or LITHIUM
GREASE:
At every 5000 mile (8000 km) service interval.
Inspect all electrical equipment and switches, including
starter interlock for proper operation:
At the 1000 mile (1600 km) initial service and every 2500
mile (4000 km) service interval thereafter.
TESTING INTERLOCK
The starter/ignition interlock system is designed to prevent
unintended start-up and/or forward motion of the motorcycle.
One of three conditions must exist to allow operation of the
vehicle:
Clutch disengaged (lever pulled in - must be done when-
ever starting motorcycle).
Transmission in neutral.
Sidestand retracted.
If the motorcycle starts and operates without any of the three
conditions being met, see 7.11 STARTER/IGNITION INTER-
LOCK, for troubleshooting procedures.
TESTING SWITCHES
Check the following electric switches for proper operation:
Left and right directional signals and dash indicator.
Neutral indicator light on dash.
Headlamp low and high beam, high beam flash and high
beam indicator light.
Oil pressure indicator light.
Odometer reset switch.
Tail lamp.
Brake lamp with both front and rear brake application.
Speedometer.
Horn.
Ignition stop/run switch.
Electric starter switch.
2004 Buell P3: Maintenance 1-39