Buell Blast 2014 Service Manual page 55

HOME
NOTE
Do not place belt on sprocket teeth at this time. Alignment of
parts will be difficult. Resting belt next to teeth allows slack for
easier alignment of wheel assembly.
22. Hold left side spacer in place and slide caliper and car-
rier over rotor.
23. See Figure 1-21. Slide axle through washer, swing arm,
carrier, left side spacer and wheel assembly.
a. Hold right side spacer in place.
b. Insert axle through right side spacer and swingarm.
c. Install flat washer, lockwasher and axle nut.
24. Place screwdriver or rod through axle hole and torque
rear axle nut to 48-52 ft-lbs (65.1-70.5 Nm).
25. Slide belt on sprocket teeth by rotating wheel to "walk"
belt onto teeth.
26. Lower motorcycle rear wheel.
27. Connect negative battery cable to battery. Tighten fas-
tener to 60-96 in-lbs (6.8-10.9 Nm).
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
28. Install seat. See 2.28 SEAT.
1-24 2004 Buell P3: Maintenance
WARNING
7701
6
5
4
1. Axle
2. Axle nut (metric)
3. Lockwasher
4. Washer
5. Spacer
6. Sprocket bolts (5)
7. Sprocket cover
Figure 1-21. Rear Axle, Right Side
7
1
2
3