Turn Signal Flasher - Buell Blast 2014 Service Manual

HOME

TURN SIGNAL FLASHER

REMOVAL
NOTE
The turn signal flasher is not repairable. Replace the unit if it
fails.
1. Remove seat. See 2.28
11 1
WARNING
Always disconnect the negative battery cable first. If the
positive cable should contact ground with the negative
cable installed, the resulting sparks may cause a battery
explosion that could result in death or serious injury.
2. Disconnect negative battery cable.
3. Pry tab on circuit breaker clip left side and remove circuit
breaker from clip with wires still attached.
4. See Figure 7-70. Remove screw and flasher relay from
frame tray.
5. Unplug relay connector [30] from flasher relay and
remove flasher relay.
INSTALLATION
1. See Figure 7-70. Connect relay connector [30] to new
turn signal flasher relay.
2. Attach flasher relay to frame tray with screw. Tighten
screw to 48-60 in-lbs (5.4-8 Nm).
3. Install circuit breaker to clip.
4. Connect negative battery cable to battery terminal.
Tighten fastener to 60-96 in-lbs (6.8-10.9 Nm).
11 1
WARNING
Check for proper turn signal operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper turn signal operation could
result in death or serious injury.
5. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control of vehicle and death or serious injury.
6. Install seat. See 2.28 SEAT.
7-54 2004 Buell P3: Electrical
SEAT.
WARNING
WARNING
WARNING
7808
2
3
1. Mounting screw
2. Flasher relay
3. Connector [30]
Figure 7-70. Turn Signal Flasher
7.20
1