Buell Blast 2014 Service Manual page 132

HOME
INSTALLATION
1. See Figure 2-95. Install fork assemblies through upper
and lower triple clamps.
3766
Figure 2-95. Installing Fork Assemblies
NOTE
When installing the front forks, use a screwdriver to pry apart
the triple clamps.
3777
Figure 2-96. Location of Anti-Seize
on Triple Clamp Pinch Screws
2. See Figure 2-96. Apply LOCTITE ANTI-SEIZE to the
threads of triple clamp pinch screws.
3765
Figure 2-97. Upper and Lower Triple Clamp Pinch Screws
3. See Figure 2-97. Align and secure fork assemblies.
a. Position fork assemblies so that top of each slider
tube is flush with the top surface of upper triple
clamp. Be sure that top surface of fork is not below
top surface of upper triple clamp.
b. Tighten upper triple clamp pinch screws (at sliders)
to 13-16 ft-lbs (18-22 Nm).
c. Tighten lower triple clamp pinch screws to 22-29 ft-
lbs (30-39 Nm).
d. See Figure 2-98. Tighten headlamp brackets flush
against bottom of top triple clamp.
a0065aSx
Figure 2-98. Tighten Headlamp Bracket Screws
4. Install front fender. See
5. Install front wheel. See 2.5 FRONT
6. Install front brake caliper. See
CALIPER.
7. Align headlamp. See 1.23
2.23 FENDERS.
WHEEL.
2.11 FRONT BRAKE
HEADLAMP.
2004 Buell P3: Chassis 2-53