Buell Blast 2014 Service Manual page 342

HOME
• Ignition On, Sidestand Up, transmission in Neutral
• Measure Voltage At Breakout Box- Multimeter Red Lead To LT GN/
GY (Pin 5) (+) and Black Lead To BK (Pin 6) (-).
Is voltage 0.6-0.8 VDC?.
YES
Remove Timer Cover (See Ignition Module/
Cam Position Sensor for procedure).
Crank Engine.
Is LED Flashing?
YES
3 Replace Ignition Module.
3 Inspect ignition module for signs of
physical contact with rotor cup.
Replace rotor cup if necessary.
Harness Adapters (HD-42962)
7-8 2004 Buell P3: Electrical
Go to Next Page. Begin
NO
Is Rotor Cup Rotating?
5009
YES
Replace Ignition Module.
3
7793
Coil
Figure 7-6. No Spark At Spark Plug
[10]
1 6
2 5
4
3
NO
at top.
NOTE
Male connectors are labeled "A"
Female connectors are labeled "B"
NO
Remove Gearcase Cover.
Inspect For Mechanical Failure.
5009
Repair.
Connector [10]
5005