Specifications - Buell Blast 2014 Service Manual

HOME

SPECIFICATIONS

NOTE
Service wear limits are given as a guideline for measuring
components that are not new. For measurement specifica-
tions not given under SERVICE WEAR LIMITS, see NEW
COMPONENTS.
Type
Compression Ratio
Bore
Stroke
Engine Displacement
Oil Capacity (with filter change)
Timing Advance (during engine cranking)
Timing Advance (at 1200 RPM)
Regular Idle
Fast Idle
VALVE
Fit in guide Exhaust
Intake
Seat width
Stem protrusion from cylinder valve
pocket
OUTER VALVE SPRING
Free length
Intake 1.751-1.848 in. (closed)
1.286-1.383 in. (open)
Exhaust 1.751-1.848 in. (closed)
1.332-1.429 in. (open)
Table 3-1. General Specifications
GENERAL
Table 3-2. Ignition Specifications
ENGINE IGNITION SPECIFICATIONS
Table 3-3. Valve and Valve Seat Specifications
NEW COMPONENTS
inches
0.0015-0.0033
0.0008-0.0026
0.040-0.062
1.975-2.011
Table 3-4. Outer Valve Spring Specifications
NEW COMPONENTS
2.105-2.177 in.
72-92 lbs
183-207 lbs
72-92 lbs
171-195 lbs
Single cylinder, air cooled, four-stroke
9.2: 1
3.50 in.
3.125 in.
30 cu. in.
2.0 quarts
1° BTDC
20° BTDC
1200 RPM
2000 RPM
mm
0.0381-0.0838
0.0200-0.0700
1.016-1.575
50.165-51.079
53.467-55.296 mm 2.105 in. (min)
33-42 kg
83-94 kg
33-42 kg
78-88 kg
3.1
88.8 mm
79.375 mm
492 cc
1.89 liters
SERVICE WEAR LIMITS
inches mm
0.0040 0.1016
0.0035 0.0889
0.090 2.286
2.031 51.587
SERVICE WEAR LIMITS
53.467 mm (min)
2004 Buell P3: Engine 3-1