Front And Rear Isolators - Buell Blast 2014 Service Manual

HOME

FRONT AND REAR ISOLATORS

FRONT ISOLATOR
Removal
1. Remove seat. See 2.28 SEAT.
2. Remove fuel tank. See
TANK.
3. Raise motorcycle until front suspension is unloaded.
4. Remove muffler, and support motor with jack. When iso-
lator is detached, powertrain may move. See
EXHAUST SYSTEM.
5. Cut horn cable strap.
6. Remove clutch cable tie.
7. See Figure 2-120. Loosen front ground strap bolt for
clearance.
8. See Figure 2-121. Remove two outboard isolator bolts
(1).
9. Remove main isolator bolt and nut (2). Discard nut.
10. Remove isolator.
Installation
1. See Figure 2-121. Position new isolator in frame.
2. Install two outboard isolator bolts (1). Tighten 30-33 ft-lbs
(41-45 Nm).
3. Install main isolator bolt and new nut (2). Tighten main
isolator bolt to 63-70 ft-lbs (85-95 Nm).
4. Tighten front ground strap bolt to 30-33 ft-lbs (41-45
Nm).
5. Install clutch cable to clip.
6. Install horn cable strap.
7. Install fuel tank. See
TANK.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation, causing loss of control of vehi-
cle and death or serious injury.
8. Install seat. See 2.28 SEAT.
4.2 FUEL TANK COVER/FUEL
4.2 FUEL TANK COVER/FUEL
WARNING
2.20
Figure 2-120. Front Ground Strap Bolt
7744
2
1. Outboard isolator bolts (2)
2. Main isolator nut
Figure 2-121. Front Isolator Bolts
2.31
7746
1
2004 Buell P3: Chassis 2-71