Buell Blast 2014 Service Manual page 300

HOME
ASSEMBLY
1. See Figure 6-9. Assemble inner and outer ramp.
a. Apply multi-purpose grease to balls and ramps.
b. Insert balls in sockets of outer ramp.
c. Install inner ramp on hub of outer ramp with tang
180° from hook of outer ramp.
d. Install new retaining ring in groove of outer ramp
hub.
2. See Figure 6-10. Install ramp assembly.
a. Fit coupling over cable end with rounded side
inboard, the ramp connector button outboard.
b. With retaining ring side of ramp assembly facing
inward, place hook of ramp around coupling button.
c. Rotate assembly counterclockwise until tang on
inner ramp fits in slot of primary cover.
3. Secure assembly in place.
a. Thread nut on adjusting screw until slot of screw is
accessible with a screwdriver.
b. Turn adjusting screw counterclockwise until resis-
tance is felt.
c. Adjust clutch release
CLUTCH.
d. Fit nut hex into recess of outer ramp.
4. Install left footpeg support bracket. See
PEGS AND FOOTPEG SUPPORT
11 1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
5. Connect negative battery cable to battery terminal.
Tighten fastener to 60-96 in-lbs (6.8-10.9 Nm).
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
6. Install seat. See 2.28 SEAT.
6-8 2004 Buell P3: Drive/Transmission
mechanism. See
2.21 FOOT-
BRACKETS.
WARNING
WARNING
a0112x6x
2
1
1. Outer ramp
2. Balls (3)
3. Tang
1.10
4. Retaining ring
5. Inner ramp
6. Hook
Figure 6-9. Inner & Outer Ramp
7688
2
3
4
5
1. Outer ramp
2. Slot of primary cover
3. Adjusting screw
4. Nut
5. Cable end
6. Coupling
Figure 6-10. Nut & Outer Ramp
3
4
5
6
1
6