Buell Blast 2014 Service Manual page 237

HOME
7662
2
4
1. Air gun
2. Head screw with ball inside
3. Cylinder stud
4. Shoulder on cylinder stud
Figure 3-133. Cylinder Studs
15. See Figure 3-133. Install cylinder studs.
a. Pack clean towels into crankcase opening.
b. Place a steel ball into a head screw.
c. The cylinder studs have a shoulder at the lower end.
Place the end of the stud without the shoulder into
the head screw.
d. Install the stud in the crankcase with the shoulder
end down. Use an air gun to drive the stud until the
shoulder reaches the crankcase.
e. Remove air gun. Use a torque wrench to tighten
stud to 10-20 ft-lbs (14-27 Nm).
3-82 2004 Buell P3: Engine
1
3
16. Install piston and cylinder. See
TON.
17. Install oil pump. See 3.12 OIL
18. See 3.15 GEARCASE COVER AND CAM
Install cam gears, gearcase cover, lifter guides and lift-
ers.
19. Install cylinder head. See
20. Install starter. See 5.7 STARTER.
21. Install shift linkage.
22. Install all primary drive components. This includes
engine sprocket, primary chain, complete clutch assem-
bly, engine sprocket nut and mainshaft nut. See
MARY DRIVE/CLUTCH.
23. Install primary cover. See
NOTE
Be sure to refill transmission to proper level with fresh lubri-
cant. See 1.11 TRANSMISSION/PRIMARY
24. See 3.4 ENGINE INSTALLATION
cable steps.
3.6 CYLINDER AND PIS-
PUMP.
GEARS.
3.5 CYLINDER HEAD.
6.4 PRI-
6.2 PRIMARY CHAIN.
FLUID.
and perform the appli-