Bank Angle Sensor - Buell Blast 2014 Service Manual

HOME

BANK ANGLE SENSOR

REMOVAL
1. Remove seat. See 2.28
11 1
WARNING
To protect against shock and accidental start-up of vehi-
cle, disconnect the negative battery cable before proced-
ing. Inadequate safety precautions could result in death
or serious injury.
2. Disconnect negative battery cable from battery.
8261
3
2
1. Bank angle sensor
2. Connector [134]
3. Locknut
Figure 7-11. Bank Angle Sensor Removal
3. See Figure 7-11. Remove circuit breaker from mounting
bracket.
4. Remove allen head screw from mounting bracket while
holding locknut on bank angle sensor side.
5. Remove bank angle sensor from its mounting location.
6. Disconnect connector [134] from bank angle sensor.
7. Remove bank angle sensor.
SEAT.
WARNING
1
INSTALLATION
1. Connect connector [134] to new bank angle sensor.
8262
3
1. Circuit breaker bracket
2. Allen screw
3. Locating post
Figure 7-12. Bank Angle Sensor Installation
2. See Figure 7-12. Position bank angle sensor in mounting
position on circuit breaker bracket mounting screw. Make
sure sensor locating post engages hole in trunk to
ensure proper alignment of sensor.
3. Install bank angle sensor with allen screw and locknut.
Tighten screw to 25-27 in-lbs (2.8-3.1 Nm).
4. Install circuit breaker to circuit breaker mounting bracket.
11 1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion resulting in personal injury.
5. Install negative battery cable to battery terminal. Tighten
fastener to 60-96 in-lbs (6.8-10.8 Nm).
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control of vehicle and result in death or serious
injury.
6. Install seat. See 2.28 SEAT.
2004 Buell P3: Electrical
7.5
1
2
WARNING
WARNING
7-13