Alternator - Buell Blast 2014 Service Manual

HOME

ALTERNATOR

REMOVAL/DISASSEMBLY
1. Remove seat. See 2.28
11 1
WARNING
To protect against shock and accidental start-up of vehi-
cle, disconnect the negative battery cable before proced-
ing. Inadequate safety precautions could result in death
or serious injury.
2. Disconnect negative battery cable from battery.
3. Remove primary cover. See
4. Remove clutch assembly, primary chain and engine
sprocket/rotor assembly as a unit. See
DRIVE/CLUTCH.
5. Remove/disassemble rotor and/or stator, as required.
Refer to the following procedures.
Rotor
1. See Figure 7-52. Remove the eight bolts which secure
alternator rotor to engine sprocket.
7805
Figure 7-52. Rotor Assembly
7-40 2004 Buell P3: Electrical
SEAT.
WARNING
6.2 PRIMARY CHAIN.
6.4 PRIMARY
7806
4
1. Arbor press
2. Rotor
3. Sprocket
4. Blocking
Figure 7-53. Removing Rotor From Sprocket
2. See Figure 7-53. Position blocking under rotor. Press
sprocket free of rotor.
NOTE
Resistance to sprocket/rotor disassembly is due in part to the
magnetic force of the permanent rotor magnets.
7.14
1
2
3