Table of Contents
Advertisement
stationary objects that are far away, on-
coming traffic, or leading vehicles with
the same or higher rate of speed.
• FCW will be disabled like ACC, with the
unavailable screens.
Service FCW Warning
If the system turns off, and the DID displays:
• ACC/FCW Unavailable Service Required
• Cruise/FCW Unavailable Service Required
This indicates there is an internal system fault.
Although the vehicle is still drivable under nor-
mal conditions, have the system checked by an
authorized dealer.
PARKSENSE® REAR PARK
ASSIST — IF EQUIPPED
The ParkSense® Rear Park Assist system pro-
vides visual and audible indications of the dis-
tance between the rear fascia and a detected
obstacle when backing up, e.g. during a parking
maneuver. Refer to "ParkSense® System Us-
age Precautions" in this section for limitations of
this system and recommendations.
ParkSense® will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense® can be active only when the shift
lever is in REVERSE. If ParkSense® is enabled
at this shift lever position, the system will remain
active until the vehicle speed is increased to
approximately 7 mph (11 km/h) or above. The
system will become active again if the vehicle
speed is decreased to speeds less than ap-
proximately 6 mph (9 km/h).
ParkSense® Sensors
The four ParkSense® sensors, located in the
rear fascia/bumper, monitor the area behind the
vehicle that is within the sensors' field of view.
The sensors can detect obstacles from approxi-
mately 12 in (30 cm) up to 79 in (200 cm) from
the rear fascia/bumper in the horizontal direc-
tion, depending on the location, type and orien-
tation of the obstacle.
ParkSense® Warning Display
The ParkSense® Warning screen will only be
displayed if Sound and Display is selected from
the Uconnect® System. Refer to "Uconnect®
Settings" in "Understanding Your Instrument
Panel" for further information.
The ParkSense® Warning screen is located
within the Driver Information Display (DID). It
provides visual warnings to indicate the dis-
tance between the rear fascia/bumper and the
detected obstacle. Refer to "Driver Information
Display (DID)" in "Understanding Your Instru-
ment Panel" for further information.
ParkSense® Display
When the vehicle is in REVERSE, the warning
display will turn ON indicating the system sta-
tus.
The system will indicate a detected obstacle by
showing a single arc in one or more regions
based on the obstacle's distance and location
relative to the vehicle.
If an obstacle is detected in the center rear
region, the display will show a single solid arc in
the center rear region and will produce a one-
half second tone. As the vehicle moves closer to
the obstacle, the display will show the single arc
103
Advertisement
Chapters
Table of Contents
