Service Fcw Warning; Parksense Rear Park Assist - If Equipped; Parksense Sensors; Parksense Warning Display - Dodge Challenger 2016 Operating Information Manual

Hide thumbs Also See for Challenger 2016:
Table of Contents

Advertisement

stationary objects that are far away, on-
coming traffic, or leading vehicles with
the same or higher rate of speed.
• FCW will be disabled like ACC, with the
unavailable screens.

Service FCW Warning

If the system turns off, and the DID displays:
• ACC/FCW Unavailable Service Required
• Cruise/FCW Unavailable Service Required
This indicates there is an internal system fault.
Although the vehicle is still drivable under nor-
mal conditions, have the system checked by an
authorized dealer.
PARKSENSE REAR PARK
ASSIST — IF EQUIPPED
The ParkSense Rear Park Assist system pro-
vides visual and audible indications of the dis-
tance between the rear fascia and a detected
obstacle when backing up, e.g. during a parking
maneuver. Refer to "ParkSense System Usage
Precautions" in this section for limitations of this
system and recommendations.
ParkSense will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is en-
abled at this gear selector position, the system
will remain active until the vehicle speed is
increased to approximately 7 mph (11 km/h) or
above. The system will become active again if
the vehicle speed is decreased to speeds less
than approximately 6 mph (9 km/h).

ParkSense Sensors

The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the
vehicle that is within the sensors' field of view.
The sensors can detect obstacles from approxi-
mately 12 inches (30 cm) up to 79 inches (200
cm) from the rear fascia/bumper in the horizon-
tal direction, depending on the location, type
and orientation of the obstacle.

ParkSense Warning Display

The ParkSense Warning screen will only be
displayed if Sound and Display is selected from
the Uconnect System. Refer to "Uconnect Set-
tings" in "Understanding Your Instrument Panel"
for further information.
The ParkSense Warning screen is located
within the Driver Information Display (DID). It
provides visual warnings to indicate the dis-
tance between the rear fascia/bumper and the
detected obstacle. Refer to "Driver Information
Display (DID)" in "Understanding Your Instru-
ment Panel" for further information.

ParkSense Display

When the vehicle is in REVERSE and an ob-
stacle has been detected, the warning display
will turn ON indicating the system status.
The system will indicate a detected obstacle by
showing a single arc in one or more regions
based on the obstacle's distance and location
relative to the vehicle.
If an obstacle is detected in the center rear
region, the display will show a single solid arc in
the center rear region and will produce a one-
half second tone. As the vehicle moves closer to
the obstacle, the display will show the single arc
moving closer to the vehicle and the sound tone
will change from slow, to fast, to continuous.
105

Advertisement

Table of Contents
loading

Table of Contents