Dodge Challenger 2015 Operating Information Manual page 152

audible alert when the turn signal is on. When
"Off" is selected, the Blind Spot Monitor (BSM)
system is deactivated. To change the Blind Spot
Alert status, press the "Off," "Lights" or "Lights &
Chime" button on the touchscreen. Then press
the back arrow button on the touchscreen.
NOTE:
If your vehicle has experienced any damage
in the area where the sensor is located, even
if the fascia is not damaged, the sensor may
have become misaligned. Take your vehicle
to an authorized dealer to verify sensor
alignment. Having a sensor that is mis-
aligned will result in the BSM not operating
to specification.
• ParkView® Backup Camera Active
Guidelines
Your vehicle may be equipped with the
ParkView® Rear Back Up Camera Active
Guidelines that allows you to see active guide-
lines over the ParkView Back up camera display
whenever the shift lever is put into REVERSE.
The image will be displayed on the radio touch-
screen display along with a caution note to
"check entire surroundings" across the top of
the screen. After five seconds, this note will
disappear. To make your selection, press the
"ParkView Backup Camera Active Guidelines"
button on the touchscreen, until a check-mark
appears next to setting, indicating that the set-
ting had been selected. Press the back arrow
button on the touchscreen to return to the
previous menu.
• ParkView® Backup Camera Delay
When the vehicle is shifted out of REVERSE
(with camera delay turned OFF), the rear cam-
era mode is exited and the navigation or audio
screen appears again. When the vehicle is
shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic
grid lines will be displayed for up to 10 seconds
after shifting out of "REVERSE" unless the
forward vehicle speed exceeds
(12 km/h), the transmission is shifted into
"PARK" or the ignition is switched to the OFF
position. To set the ParkView® Backup Camera
Delay press the "Controls" button on the touch-
screen, the "settings" button on the touch-
screen, then the "Safety & Driving Assistance"
button on the touchscreen. Press the "Parkview
Backup camera Delay" button on the touch-
screen to turn the ParkView® Delay ON or OFF.
• Rain Sensing Auto Wipers
When this feature is selected, the system will
automatically activate the windshield wipers if it
senses moisture on the windshield. To make
your selection, press the "Rain Sensing" button
on the touchscreen, until a check-mark appears
next to setting, indicating that the setting had
been selected. Press the back arrow button on
the touchscreen to return to the previous menu.
• Hill Start Assist — If Equipped
When this feature is selected, the Hill Start
Assist (HSA) system is active. Refer to "Elec-
tronic Brake Control System" in "Starting And
Operating" for system function and operating
8 mph
information. To make your selection, press the
"Hill Start Assist" button on the touchscreen,
until a check-mark appears next to setting,
indicating that the setting had been selected.
Press the back arrow button on the touchscreen
to return to the previous menu.
149